DAPAudio P-700 Uživatelská příručka

Palladium P-400 ORDERCODE D4131(B) P-500 ORDERCODE D4132(B) P-700 ORDERCODE D4133(B) P-900 ORDERCODE D4134(B) P-1200 ORDERCODE D4135(B) P-

9 Connecting Outputs Speakers can be connected using Banana plugs, Speakon plugs or bare wire to the binding posts on the rear panel of the amplifier

10 Bridged Mono Operation Both amplifier channels can be bridged together to make a very powerful single channel amplifier. When the Mode switch is s

11 Signal-LED This green LED lights, when its channel produces an output signal of about 4 Volt RMS or more (0,1V or more at the input, with 0dB att

12 Connection Cables Take care of your cables, always holding them by the connectors and avoiding knots and twists when coiling them: This gives the

13 Maintenance The DAP Audio Palladium-series requires almost no maintenance. However, you should keep the unit clean. Disconnect the mains pow

14 Product Specification Specification P-400 P-500 P-700 P-900 P-1200 P-1600 P-2000 8 Ω Stereo Power (RMS) 150W 180W 240W 350W 530W 6

15 Wire Gauge Chart (Metric) Stranded Cable Wire Gauge Power Loss % Power Loss % Power Loss % Length (m) (8 ohm load) (4 ohm load) (2 ohm

16 Wire Gauge Chart (AWG: American Wire Gauge) Stranded Cable Wire Gauge Power Loss % Power Loss % Power Loss % Length(ft) (AWG) (8 ohm

1 Congratulations! You have bought a great, innovative product from DAP Audio. The DAP Audio Palladium Series brings excitement to any venue. Whether

2 DAP Audio DAP Audio Palladium™ Product Guide Warning ...

3 Warning Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all p

4  Only use device indoor, avoid contact with water or other liquids.  Only operate the fixture after having checked that the housing is firmly c

5 Connection with the mains Connect the device to the mains with the power-plug. Always pay attention, that the right color cable is connected to the

6 Description of the device Features The Palladium is an amplifier from DAP Audio. There are 7 different versions: P-400, P-500, P-700, P-900, P-120

7 Backside Fig. 2 5) IEC Power connector 6) Fuse 7) 5-way Binding post + output Connectors 8) Signal Ground Lift Switch 9) Bridged

8 Installation Remove all packing materials. Check that all foam and plastic padding has been removed. Secure the equipment into a 19" rack. Con